openstack.03_l3vpn_bgp_multipath_maxpath_cli Documentation: The objective of this testsuite is to test QBGP and ODL for multipath/ECMP support. QBGP should be capable to receive multiple ECMP paths from different DC-GWs and to export the ECMP paths to ODL instead of best path selection. ODL should be capable to receive ECMP paths and it should program the FIB with ECMP paths. Source: /w/workspace/netvirt-csit-3node-0cmb-1ctl-2cmp-openstack-stein-dcgw-magnesium/test/csit/suites/netvirt/l3vpn_bgp/l3vpn_bgp_multipath_maxpath_cli.robot Start / End / Elapsed: 20200721 16:08:40.666 / 20200721 16:12:14.828 / 00:03:34.162 Status: 5 critical test, 0 passed, 5 failed 5 test total, 0 passed, 5 failed Message: Suite setup failed: Keyword 'BgpOperations.Verify BGP Neighbor Status On Quagga' failed after retrying for 2 minutes. The last error was: 'BGP neighbor is 10.30.170.142, remote AS 100, local AS 100, internal link BGP version 4, remote router ID 0.0.0.0 BGP state = Active Last read 00:02:05, hold time is 180, keepalive interval is 60 seconds Message statistics: Inq depth is 0 Outq depth is 0 Sent Rcvd Opens: 0 0 Notifications: 0 0 Updates: 0 0 Keepalives: 0 0 Route Refresh: 0 0 Capability: 0 0 Total: 0 0 Minimum time between advertisement runs is 5 seconds For address family: IPv4 Unicast Community attribute sent to this neighbor(both) 0 accepted prefixes For address family: VPN-IPv4 Unicast Community attribute sent to this neighbor(both) 0 accepted prefixes Connections established 0; dropped 0 Last reset never Next connect timer due in 1 seconds Read thread: off Write thread: off bgpd# ' does not contain 'BGP state = Established'